During transportation, the power cord cables of the top and bottom panels may become loose, or they may become unstable after prolonged use. If this happens, you'll need to replace the power cords.
STEPS:
Power off your Hey abby grow box;
Use a Phillips screwdriver to loosen the 6 screws inside the device, open the top cover, unplug the cables, and remove the top cover to find the power cord. (Tip: Take a photo before unplugging the cables to ensure correct reconnection during reassembly.)
Find the power cord connected to the top panel. Use tape to bind the new and old cables together (this makes replacing the cord easier).
Remove the water tank from the device. Use a Phillips screwdriver to remove the 2 screws at the bottom left side of the machine to find the power cord.
Use a screwdriver to loosen the 3 screws on the door lock and remove the door lock.
Loosen the 8 screws on the back cover of the device. Locate the power cord connector as shown in the picture, and follow this connector to find the power cord.
First, slowly pull the power cord from inside the box in the direction of the arrows. Once the power cord is pulled out, move to the back of the device and continue pulling the cord.
Once the power cord is out, untie the new and old cables and insert the new one into the bottom panel. Reinstall the door lock, top cover (don’t forget to reconnect the cables to the top panel), and water tank.